Aminopropyl-CPG; 1400 Å

We compare how (i) four ionic liquids (ILs) (1-butyl-3-methylimidazolium tetrafluoroborate ([C4mim][BF4]), 1-butyl-3-methylimidazolium bis(trifluoromethylsulfonyl)imide ([C4mim][Tf2N]), 1-butyl-1-methylpyrrolidinium bis(trifluoromethylsulfonyl)imide ([C4mpy][Tf2N]), and trihexyltetradecylphosphonium bis(trifluoromethylsulfonyl)imide ([P(C6)3C14][Tf2N])) and (ii) two conventional molecular liquids (methanol and 1-octanol) solvate/wet luminescent organic moieties that are covalently attached to the surface of silica controlled pore glass (CPG). A series of aminopropyl CPG particles that have been covalently tagged with the solvatochromic fluorescent probe group dansyl were used in this study. The results demonstrate that ILs solvate/wet the silica surface differently in comparison to molecular liquids (MLs). Specifically, when comparing ILs and MLs that appear to solvate the free probe, dansylpropylsulfonamide (DPSA), equally in solution, we find that ILs do not solvate/wet the silica surfaces as well as the corresponding MLs. The cation component in these ILs is the significant factor in how the ILs solvate/wet silica surfaces. Solvation/wetting of surface-bound species at a silica surface depends on the cation size. Chlorosilane end-capping of the surface silanol and amine residues attenuates the cation's affects.

A general method is described for the solid phase supported synthesis of DNA containing 3'-terminal phosphodiesters modified with linkers bearing either amino, thiol, or hydroxyl groups. These products are all made from a common intermediate, obtained by the reaction of trimellitic anhydride chloride with aminopropyl CPG. The anhydride-derivatized support was then reacted with three appropriate bifunctional spacers, giving DMT-protected hydroxyl solid supports bearing the masked functionality as an ester, amide, or thioester. DNA synthesis was then performed, followed by ammonia cleavage and deprotection, giving the hydroxyl-, amino-, or thiol-functionalized DNA 3'-phosphate diesters, respectively. Test mononucleotides synthesized with each of the new supports were identical with control mononucleotides made with 5'-immobilized nucleosides and alkylhydroxyl, alkylamino, and alkylthio phosphoramidites. The new supports were then used to prepare several 3'-modified oligonucleotides, which were characterized by gel electrophoresis, HPLC, and MALDI mass spectroscopy. The amino- and thiol-functionalized DNAs were conjugated with chromophores, and purification of these products was facilitated by use of reversed phase cartridges.

In developing therapeutic immunoadsorbents (IAs), antibodies (IgG molecules) covalently immobilized on porous carriers, a leak of IgG was determined both in the storage test with buffers at 25 and 4 degrees C and in contact with plasma at room temperature (RT). The amount of antibody released from therapeutic IAs must be minimized to avoid side effects during treatment. The amount of IgG released was a. Dependent on the amount of IgG immobilized b. Much greater with CNBr-activated Sepharose 4B, or Formyl-Cellulofine as a support material than with aminopropyl CPG (controlled pore glass) c. Found to yield again during another storage in buffers after the IAs were washed and their buffers replaced with fresh ones and d. Decreased after the IAs were treated with glutaraldehyde (GA) solutions. Whereas treating the IAs with GA solutions significantly reduced the amount of IgG released, it caused some deterioration of the adsorption characteristics of the IAs. An irradiation dose of 2.5 Mrad as a crosslinking procedure also reduced the amount of IgG released; its effect was comparable to that of 0.025% GA, the lowest concentration used.